Categories
Contact Us
Add: The Daqiao Town of Tianqiao District,Jinan City, Shandong Province, China
Tel: +86-531-88075155
Mob: +8615562570081
E-mail: ikcnc@ikcnc.com
News
Home > News > Content
Operation Procedure Of Stone Cutting Machine
Dec 21, 2018

Before work

1. Wear overalls, bring good anti-eyepiece, female hair will hair on the plate to put on the work cap.

2. The power supply Gate knife switch, the tightness of the saw blade, the saw blade shield or the safety bezel for detailed inspection, the operator station must be solid, night work should be adequate lighting.

3. Turn on the main switch, the empty test turn a few laps, to be confirmed safe before allowing startup.


At work 

1. Wear gloves is strictly prohibited.

If it causes dust during operation, wear a mask or mask.

2. Do not attempt to cut saws of small workpieces that are not clamped.

4. The cutting machine is only allowed to cut the profile.

5. Do not carry out strong sawing operation, before cutting to achieve full speed of the motor.

6. No one is allowed to stand behind the saw.

7. Do not lean over or bypass the sawing machine, and do not loosen any hand or lift the arm from the saw or workpiece when the saw blade does not stop.

8. Do not operate when the shield is not in place, do not place the hand within 15 cm of the saw blade.

9. Before repairing or replacing the fittings, the power supply must be cut off and the saw blade should be stopped completely.

10. If an abnormal sound is found, the inspection should be stopped immediately.


After work

1. Turn off the total power supply. 

2. Clean and tidy the work desk and venue.



  • Newsletter
  • Categories
  • Contact Us
    Add: The Daqiao Town of Tianqiao District,Jinan City, Shandong Province, China
    Tel: +86-531-88075155
    Mob: +8615562570081
    E-mail: ikcnc@ikcnc.com
  • QR Code
  • Copyright © Jinan IKCNC Technology Co.,Ltd. All Rights Reserved.